Roller coating machine usage tutorial（1）

First, connect the power supply, air source, and paint pump to the roller coating machine.

Turn the red button in the upper left corner of the operation screen to turn on the machine.

Adjust the gap between the rubber roller and the squeeze roller, and observe that the reader needs to be adjusted to "50 wires" ("0" means just fit).

Both left and right roller groups should be adjusted to "50 wires".

Use the paint pump that comes with the roller coating machine and put the pump suction tube into the paint bucket.

Open the air inlet valve and adjust the air pressure to 0.2 MPa.

Open the two paint supply valves to allow the paint to circulate.

Enter the parameters of "delivery frequency", "front rubber roller frequency", "front squeeze roller frequency", "rear rubber roller frequency", and "rear squeeze roller frequency" on the roller coating machine touch screen.

Roller coating machine conveying frequency: 20; front rubber roller frequency: 24; front squeeze roller frequency: 24; rear rubber roller frequency: 26; rear squeeze roller frequency: 26;

The frequencies of the rubber rollers and squeeze rollers in the same group are the same.

The frequency of the rear roller group of the forward and Reverse Roller Coating Machine is faster than that of the front roller group.

The front and rear groups of the double forward roller coating machine have the same frequency, and the conveying frequency is the slowest.